Peerless-av GC-UNV - Installation Bedienungsanleitung PDF herunterladen (Seite 9)

Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.

9 of 13

ISSUED: 01-28-11 SHEET #:125-9176-1

Installation to Wood Stud Wall

Use a stud nder to locate the edges of the stud. Use of an edge-to-edge stud nder is highly recommended.

Based on their edges, draw a vertical line down each stud center. Place wall plate (B) on wall as a template. Level,

and mark the center of the three mounting holes. Make sure that the mounting holes are on the stud center lines.

Drill three 5/32" (4 mm) dia. holes 2.5" (64 mm) deep. Fasten two #14 x 2.5" wood screws (O) leaving 1/4" of

thread exposed as shown in Figure 4.1.

Hook wall plate (B) onto exposed #14 x 2.5" wood screws (O). Secure using one #14 x 2.5" wood screws (O) as

shown in gure 4.2

Skip to Step 5.

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all

attached hardware and components.

• Tighten wood screws so that wall plate is rmly attached, but do not overtighten. Overtightening can damage the

screws, greatly reducing their holding power.

• Never tighten in excess of 80 in. • lb (9 N.M.).

• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud nder

is highly recommended.

• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-

ers are responsible to provide hardware for other types of mounting situations

WARNING

1/4"

Figure 4.1

Figure 4.2

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Peerless-av GC-UNV - Installation Bedienungsanleitung Seite 9